Full Transparency - It's a Crowdfunding Campaign but Not
So yeah, It's a Crowdunding Campaign but as Pre-Orders cause crowdfunding sites don't like firearms, or its accessories, or don't think your 2nd Amendment is worth the time... To learn more about The...
View ArticleTimeline - Update
So, Tooling times have slipped....currently looking for a new American based manufacturer so I can meed the attached timeline. Not too concerned as the few I spoke with today had a 4-5 week build time...
View ArticleKEEPING IT STATE SIDE
The Preorder sale of The Mag Feeder will extend the duration of the time the tooling takes to be made in America. Yes, I could have gone to China or Mexico at this point and completed the tooling and...
View ArticleThe Mag Feeder is in the Tooling Phase!
As February approached I have been half dreading the call to the manufacturer...as I assumed the timeline would be bumped and I would have to tell all the great people that have preordered that the...
View ArticleProduction Update - Tooling is Done but not Finished!
The manufacturer has produced 10 units for quality, fit, and functional testing. This is to say the mold (the injection mold or tooling) is done but will undergo the necessary tweaks that will be...
View ArticleProduction Update - May 14, 2018
Today we met with the manufacture to finalize the changes that need to be made for the mold to be 100%. He was confident that by the end of day the mold would have all the discussed changes made and we...
View ArticleProduction Samples Round 2
We have the 2nd round of production samples in hand and assembled, and have been testing for fit and function. Exciting! The second round of samples show a major improvement! Most notably the improved...
View ArticleProduction Update - 5/25/18
End of week update, just met with the manufacture to discuss the last small changes needed to run the first production run and we were met with some bad new as far as timeline. After sending in the...
View ArticleProduction Update - 6/1/18
End of week update. We fine running the magnet choices, apparently not all neodymium magnets are created equal, we have enough on hand for the initial orders but since we have time to get the...
View ArticleProduction Updates - 6/11/18
No new updates since last week. We have been in contact with the manufacturer and are still waiting raw materials. We have put in shop time to get all we can get done before the first production run...
View ArticleProduction Update - We are in production!
Keeping in constant contact with the manufacturer this week in regards to the receiving the raw materials, Thursday they let me know they got the materials in and would be ‘shooting’ our mold on...
View ArticleIn Production - and moving fast!
Another update already! We received 330 units from the manufacturer yesterday and have begun assembling! So excited! With all the prep we have done and the help we have we are pushing thru assembly....
View ArticleShipping The First Batch!
Today...June 21st, we have assembled and shipped our first batch of orders. In total we dropped off 49 packages to be sent out. I can't give a range of which order numbers as some orders included...
View ArticleThe Mag Feeder is Shipping Everyday!
With enough parts to fulfill all the preorders we have set up a work flow for assembly, quality control, and packaging so that we are shipping nearly everyday. We have found that many orders do not...
View ArticleOrder Fulfillment Update - 7/2/18
Small delay in shipping, ran out of packaging to ship orders out. We have 25 being sent out today but could be sending about 60 if we had all the packaging, bubble envelopes, luckily our local supplier...
View ArticleOrder Fulfillment Update - 7/8/18
Order fulfillment is nearly complete for all preorders. We have 75 orders packaged and labeled ready to drop at the post office. Which leaves us with only 30 orders left. If you Ordered before June,...
View Article
More Pages to Explore .....